SKU Code: MM25

Height (mm): 25

Length (mm): 160

Width (mm): 105

Mounting holes (mm): 14.5

Material: Galvanised Steel

---

SKU Code: MM40

Height (mm): 40

Length (mm): 160

Width (mm): 105

Mounting holes (mm): 14.5

Material: Galvanised Steel

---

SKU Code: BKV-MM40

Height (mm): 40

Length (mm): 185

Width (mm): 115

Mounting holes (mm): 14.5

Material: Galvanised Steel

Installation is easy by following the below steps,

1. Attach the operator to the motor mounts (one on each side) using the bolts that come with the operator.
2. Centre and make sure both mounts are the same distance apart (square to the operator’s base).
3. Tighten the motor down to the mounts.
4. Place the operator under the drive rack in the correct position as per the installation manual.
5. Mark the hole locations on the concrete for the screw bolts.
6. Drill one hole only with the operator moved out of the way.
7. Screw bolt the operator down so it’s over all the hole marks.
8. Pre-drill the other 3 holes 10mm deep using the mounts as a guide.
9. Remove the operator and finish drilling the new holes.
10. Now evenly bolt the operator into position and adjust as per the user manual.